Jump to content

    Im not dead yet!

    OutcastZeroOne
    By OutcastZeroOne,
    hey guys, long time no see. Kinda drifted away for a bit. Still have the 85, in peices, and hope to get back on it soon.   just wanted to stop by and say hi.

    Cracked Head/Blown Head Gasket Symptoms?

    gottraction
    By gottraction,
    So ive replaced the thermostat,radiator, hoses, that you can probaly see in my prior post. wired up the thermosensors to the neck of the thermostat. When i was driving home the car did well for about 70 miles then all of a sudden the temp gauge started going up. i noticed it actually ran alittle colder when the ac was on. But my fans are wired to kick on at the same time so its not like its adding a secondary fan. It went up about 3/4 of the way and i pulled over. eventually it ended up going ba

    Thread size of 86 IAT

    kinree
    By kinree,
    Dose any one know the thread size of the 1986 Intake temp Sensor i need to have a bung welded the the *DM ovcp

    Krank Vents....Too much Vaccuum?

    CaliConquestAlex
    By CaliConquestAlex,
    I got my car running recently and I'm noticing a loud sucking noise when the car is running which persists after the car is shut off for a couple seconds. I'm thinking this is being caused by my krank vents. When I put the car back together, I swapped the PCV valve out for a straight through fitting and therefore it's getting more flow. It worked fine when I had the PCV in the valve cover. I read that it may be necessary to run a restrictor. I'm struggling to figure out what to use as a restrict

Portal by DevFuse · Based on IP.Board Portal by IPS
×
×
  • Create New...