Did any of you see this show last night? they thought a fairmount would be a good platform for drifting.   The really messed up part was that they covered the car in mirror finish silver wrap, and black paint, which looks a lot like my mirror polished steel starion with black stripes, thats not done yet!   Those fools!   Oh well. The show is entertaining enough, but they dont know anything about drift cars.

On my way out the canyon I came upon a car club parked on the side of the road.... http://oi46.tinypic.com/330y1oy.jpg   http://oi47.tinypic.com/10wvd76.jpg   I think there were only a dozen or so. They might have been re-grouping after breakfast. Or heading over to the Sunday Coffee and Octane gathering at the Ford design center.

So I have decided that replacing the pinion seal may be a bit too big of a job for me. I don't like admitting that, but I don't want to mess up the job. So I started getting estimates. Went to Pep Boys. 2 hours labor at 109 per hour, unless the also have to remove the crush sleeve, which is another 2 hrs. What are the odds they will need to remove the crush sleeve? And why don't i see this part listed in the parts manual?   Thanks

i need a TBI rebuild kit cause its leaking from everywhere but 1 recently replaced injector,   this is one from almost every place like rock auto   this is from Napa   And mt t/b has 2 large gaskets like the one on the right from rock auto and they are leaking and rockauto only comes with 1 so wht do i do?