Jump to content

    bare 4g64 block - gauging interest

    oxorockmanoxo
    By oxorockmanoxo,
    after doing quite a bit of research and really examining my obligations. i think that the best way, and fastest way to get my starion back on the road is to stick with the g54b. i would have liked to and still want to eventually do this swap, but i dont think it will be any time soon. and i dont really want to have this block sitting in my garage.   its a bare 4g64 block that has been fully machined, honed, decked, cleaned and ready for assembly (no crank, rods, pistons, bearings, etc.). its

    Clutch, pressure plate, and throwout bearing.

    regginrx7
    By regginrx7,
    $100.00 shipped for an almost new clutch, pressure late, and throwout bearing. Bought new, installed, and drove for about 100 miles.

    88-89 5 Spd transmission

    DieHARDmitsu.
    By DieHARDmitsu.,
    This gearbox is in excellent working condition, 113k miles. Just sold my car so I no longer need it. $100+shipping

    86 tsi parts car and 87 tsi shell for sale Marion, IN 46953

    turboman5065
    By turboman5065,
    For Sale: 86 Black on black Tsi - 5 speed car No Title No Motor All else is there Interior is 6-7 out of 10 Some good panels 87 White on Maroon Tsi 5-speed car Car is stripped of interior (nothing inside) Motor and tranny removed, but go with car Motor is disassembled (bought car that way) Turbo Bad (Assuming, also disassembled when i bought it) Some good panels Have title   I'm basically selling them for parts. I had intended on putting the

Portal by DevFuse · Based on IP.Board Portal by IPS
×
×
  • Create New...