87 Quest,14g,MBC,89 ECM,21/2 exh various other upgrades. Installed this turbo over the winter and all has been well until a couple of weeks ago. When I accelerate from a stop(or rolling) boost builds pretty decent up to 15psi. When I shift and get back on the gas its like the car isnt even turbo charged. Boost barely builds and just falls flat. If I try again or throttle up from slow speed boost will build and then fall flat. All vacuum lines seem to be in order and installed tightly. Tested the

I need a pin out of a gen1 maf-t version 2.02 because I bought one from a member and it came with no plugs.

Wanting to get cracking on my Starion after waiting 4 years of setting up my business i'm now making the time to get her running.   I built a forged engine with pauter rods, JE's, balance eliminator, fully balanced RA and a fly, tep head with cam, griffin rad, basically what seemed the best from TEP at the time. This was in 2004-5.   Cutting to the chase, if I port match up my exhaust and inlet would it be safe to run the engine in on stock injection and turbo with a 2.5 exhaust, or will it be

Hello As you've might have seen in my intro, not only am I up against a full engine rebuilt, but I also have a fair bit of bodywork ahead of me. The problem I've got is that nobody in the UK supplies repair panels, so can anybody recommend a good US supplier, or is it a matter of fabricating the panels myself? Thanks in advance! Greg