I'm doing the 4g63 engine swap and I'm modifying it so that the water exits the front of the motor. I also want to go with a bypass thermostat housing from the web site at the end of this post but I can't seem to get my head wrapped around how the water flows.   So assuming I want to actually have a heater and I will do the front exit water modification to the block and head, which of the thermo housings from the following web site would make for the nicest/cleanest hose routing?   http://www.ip

Good condition - no cracks.   $70 + shipping   http://i1210.photobucket.com/albums/cc409/motocam360/Black%2088%20SQ/88wipercowls_zps65353fa7.jpg

90mm stock diameter Wiseco forged - about 4 years old Comes with wrist pins and C clips Pistons have 500 miles on them   $250   http://i1210.photobucket.com/albums/cc409/motocam360/SQ%20Engine%20Parts/forgedG54bpistons4_zpsd72ccb4d.jpg   http://i1210.photobucket.com/albums/cc409/motocam360/SQ%20Engine%20Parts/forgedG54bpistons3_zps3290dbd9.jpg   http://i1210.photobucket.com/albums/cc409/motocam360/SQ%20Engine%20Parts/forgedG54bpistons2_zpscb5cd20a.jpg   http://i1210.photobucket.com/albums/c

So my wife was driving her moms car a week or 2 ago (2012 Camry, for what its worth), and had a little boo boo while backing up     http://i141.photobucket.com/albums/r80/fijiphil/2013-06-05_16-09-33_767_zpsacf758b1.jpg   http://i141.photobucket.com/albums/r80/fijiphil/2013-06-05_16-09-17_836_zps1a04006e.jpg   http://i141.photobucket.com/albums/r80/fijiphil/2013-06-05_16-09-10_706_zps47d00bfe.jpg   So, its really not awful. The black smudges I am pretty convinced will come out with the proper b