so while installing my rear struts and springs the cv axles where its splined had pulled out from the rear diff. do i just push them back in and make sure that they are pushed in all the way when i bolt everything back together? i see that theirs a c clip on the end of the splines of the cv axle. just want to make sure everything is good when i re install. dont want to strip out the splines or ruin the rear diff. any certain way its supposed to go back together would be greatly appreciated : ) t

So i fubared one of my rear lower coilover mounts this weekend. So instead of getting another 240 one and modding it i figured if i can buy a set from d2 that be a nlot easier. Pretty sure the thread pitch is the same on most of the coilovers. So if any of you have a contact over there and could see if they will sell me just the lower mounts for the rear that would be great.

$200.00 shipped.

My daughter is sitting in the car waiting to take her drivers test... I think the wife and I are more nervous than she is. Just heard the horn, going over the safety portion. Backing out now. fingers crossed...