need to replace the wire feed sleve in my Mac Tools gas 115 volt mig welder , it's a simple 20 ft long piece of nylon tubeing 5/32 OD . I found some with .025" wall thickness $15.00 for 100 ft , just not sure it'd be thick enough what do you think or has any one been thru this

Does anyone make or have a machined plate anymore to block the distributor hole??? Needing another and looks like MK1 has finally sold out of those.

So at about 3500rpm I start to lose boost. I feel the boost up till that point, then it's like the turbo quits. The cars still accelerates, but without the boost. Now the history with this car- the previous owner put water threw it to run a test, and left the water in it- I'm wondering if there's rust possibly in there restricting the max boost. I've checked the cats, there's no restrictions that are in plan sight, I've checked all the vac lines, and don't see any that are cracked or not con

http://i778.photobucket.com/albums/yy68/jaybirdskate/06h10_zpscff92ff9.jpg