I just finished putting the dash in a car. I noticed on the back of the heat/ac controls box there are three plugs for wires. However the harness only has two plugs for it.   88 Harness, it is possible that the heating controls are 87. Thanks.

I need a pressure plate 87 5speed with bolts and I need motor mounts with bolts

So my aem gauge is reading differently then megatune. I set the ms to what the aem instructions said per 14.7 air fuel, i was about to start adjusting the ms until megatune matched what the gauge showed but before i did that i wanted to ask here what settings people usd for the aem

After a long break from my Starion I have picked the project back up and am beginning to wire my MS harness up.   I have four sensors on my MPI intake and am not sure what plugs into them so that I can connect my MS to them.   1. coolant temp 2. coolant temp   (which one do I use?)   3. air temp 4. TPS   What plugs (connectors) go into these so I can solder them to the wires on my MS harness? I can't seem to find the correct for TPS connector for the TPS sensor.   http://i.imgur.com/akweSRi.jpg