Jump to content

    Rear Brakes Grabbing/Locking. E brake.

    gabea101
    By gabea101,
    Had a mechanic replace my rear pads. After 1 week or so...I noticed a brake smell after driving it. I touched both rims and they were both warm/semi hot. After another week...it went away. This lasted 2 weeks and the brakes started grabbing again...When I was driving one day...I tried to pull the ebrake up and down real hard to see if it would help release the grab but it made it worst...the brakes were really grabbing/locking now and then I had to pull over. The brakes were locked up an

    Diy Turbo Manifolds

    Doctor_Drift
    By Doctor_Drift,
    I have been looking a the treadstone t3 manifold for a while. Today i notice the have 3 other diy manifold kits one log type one tube style and a collector style! Am i the only one to notice these are they new?   http://www.treadstoneperformance.com/product.phtml?p=2390&cat_key=698&prodname=Starion+Conquest+DIY+Log+Manifold+Kit   http://www.treadstoneperformance.com/product.phtml?p=2391&cat_key=698&prodname=Starion+Conquest+DIY+Tubular+Manifold+Kit   http://www.treadstoneperforma

    Ohio Mile? ECTA East Coast Timing Association

    jszucs
    By jszucs,
    http://ecta-lsr.net/     Seriously how have I never heard about this? So going though the new car is more tempting because of topend in it then the quest

    CLEAN 1987 QUEST!!LOW MILES-NO RUST

    allstar
    By allstar,
    I have a clean 1987 quest for sale i dont want to part with it but i need to pay a bill. I am the 2nd owner. Bought from the owner of Brickners Dodge in Merrill Wi it was his wifes car sat in storage for 12 yrs and they wanted it gone so i saved it and gone thru everything on this car cleaned and sealed gas tank, new fuel pump and all 3 filters are new. Rebuilt master cyl 1 G MAF sensor new slave cyl. 88 computer new aftermarket injectors newer head and fully rebuilt engine from crank to balance

Portal by DevFuse · Based on IP.Board Portal by IPS
×
×
  • Create New...