I purchased a pair of Audiobahn 12's (aluminum cone) and two US Acoustic's amp 's USX2150 for mids and high's and the USX1000D for the subs . I built the box to conform around the rear strut towers so I still have room for a hydraulic floor jack and my tool box and a spare drive shaft he he . I have an Alpine 7892 deck that is pretty adjustable . Man those twelves hit harder than my old system thaty had  4 15's with two 5002 Linear Power amps . I'm very happy with the ZEB .

i need to find myself some aluminum injector bosses to change the design of my intake slightly.  i bought one of chad's pre-production intakes and the injector bosses face straight down into the runner.  i think this will cause fuel to puddle on the bottom of the runner so i want to weld on some angled bosses to correct this.  does anyone have a source for these?   btw, i have seen some from SDS, but they are a bit on the pricey side, but very nice pieces.  i just need something cheaper if

would like to see a vendor secion like the previous person had posted i could creat some pages for here because Im actualy looking to make a webpage with lists of vendors and personal people with products they have made and are selling...   but need more webpages to check out.   anyone have a lot of links of vendors or anyone that would like to post there products on my page let me know.   email me at kayotic.kaos@lycos.com   Hope that my link can be on a link section of starquestclub

tdo5 ported polished will it or could it equal a tdo6 flow rate?   i want to run a td06 17c and need the td05 machined to fit the 06 wheel,   any idea how this will help flow ,  will it be more restricted than ajust running a tdo6   may be a dumb question?