any of you  guys  ever  install'd a  gauge to check the exh system back pressure i've been looking at  makeing  a fitting to  screw into the  aux air  pipe hole to check the  back pressure on  an exhaust system and was wondering if any one had check'd theirs

This is the "piss or get off the pot" cam gear GP ending 4-25-03   Anyone not interested on this list please email or PM me.   Anyone else interested between now and 4-25 please add your reply to this thread.     1)Mike K 2)Dan 3)ImportWarrior   4)boricudaquest 5)FNF 6)Phathp   7)Lizzord 8)Scotty 9)Rusky 10)Chip 11)csdisme 12) ?? 13) ??     5 gears+   - $195.00 10 gears+ - $185.00 20 gears+ - $175.00 30 gears+ - $175.00 - *** Shipping included ***       I

ive heard of people doing it cheaper then that just by modding the fuel pump ground.  thats how the ecu cuts your fuel, it turns off the fuel pump, without that you can run until you can provide fuel anymore. fcd's are about 130 arent they?

Well we did it, Found yet another way too free cheap mod the quest engine. Got the Mustang TB installed onto the stock Intake and fuel system on the Monturbo The first test shows, get this, smoother idle!!!. It seams to rev good, but it has slight studder with sharp throtal, posibly fuel geting before the air does (inj after tb), posibly the ecu isnt fast enof too respon, or could be just its geting more air then it knows what too do with it Upgraded from 2 1/4in crush bent too 2.5in now, and