Does anyone sell the hardpipes needed to run a magna intake and fuso IC? I would just rather buy them instead of making them.

last time i really worked the steering my car was pushing on the asphalt, not concrete!   my buddy has a Toyota starlet, it was doing the same, so he doubled the frot sway-bar. I have the Suspension Tech bars already on, but i may cut the ends(eyelets)oss the old stock front swaybar, and clamp it underneath the SS bar to "cure" my push. any opinions or help greatly accepted. :twisted:

Just as it says, I relocated it down below the factory radio. I did this to make room for the gauge panel I got from jolyrgr. I asked him to leave the last spot blank as I only had 2 gauges and I also had some switches and an led that needed a new location.   I lengthened the wire on the HVAC control face plate, as theres no room for the computer below the radio. The computer is still up where it was, but about 1.5 inches farther back. I cut the brackets off a spare computer I had, and am usi

I've finally started the restoration project on my '86. For a little background, those that have seen my '86 know it's far from a beater. But, I'm wanting to be back in better than perfect condition.   I was visiting my parents and pulled in to fill up the tank before I left down. When I pulled out of the gas station, I dropped my #3 intake valve, destroying my piston and head in the process. A chunk of my piston also flew into my balance shaft chain, breaking the chain. I'm using this as