Just wondering if anyone has swapped a chrysler 2.2 or 2.5 liter 4cyl turbo engine into one of these cars? I know that I could easily handle the wiring and plumbing part of it, but I'm just wondering what one would have to use for engine mounts and will the stock 2.6 transmission bolt up properly?

Im thinking about doing the opposite of what most of you guys are trying, mounting some 5-spoke starquest wheels on an older ford I have. My stock off set is zero, right down the center. Its an older rear wheel drive car.   I tried looking around but off sets, and back spacing confuse the s*** out of me. And I think there are four different versions of the 5-spoke wheel Im thinking about running?   Can I run a stock starquest wheel without needing a spacer? I think your wheels must have a

got a mpi set up with a ford throttle body... My TPS sensor is BAD! i grabbed another 1 off a mustang and it spins the oposit way! Anyone have a part number or could narrow down my serch???

by xspower and it sounds awesome when opens. with it dump in the atomsphere. 14.7psi spring. this is used and top part is silver or polish i should say. no extra flange included. asking 50 for it plus shipping   Jeff