I need new 83' long valves with the retainers and keepers. If you have any PM me or send me an email to cornelius540@yahoo.com Thanks.   Parts i also need but not as bad ---1 7" front and 1 8" rear ---A stock replacement clutch kit (cheap, just to get by and break the motor in before i go ACT) ---A winning lottery ticket if you have one laying around..

4 in to 1 header equal length stainless steel runners. has 1/2 inch thick flanges made of mild steel.   with this header you will need to modify your down pipe. this is because the turbo is now centered between the 2nd and third exhaust ports. header is new, never used, never been installed. i was just waiting to get my engine rebuilt. i never got there so i am parting with the header.   this has a T-3 flange. i wanted to run a syclone turbo but never got to use it.   also has an exhaust temp b

over the years several attempts mentioned but can't recall seeing one posted. This one looks like it works... for simultaneuous tbi ecu tho http://forums.austarion.com/viewtopic.php?t=6712 I guess you could tune a/f with a translator or safc Interesting low budget project for those who like to 'tinker'.

I require the Stedebani's polys Rear Cross member bush dimentions as no bush specialists here in Australia ever made them.   They can be custom made but i am unable to measure the originals as ive burnt the old ones out already. The picture below is what bushes i need and a diagram for measurements.   http://members.optusnet.com.au/rxcorp/bush.jpghttp://members.optusnet.com.au/rxcorp/size.jpg   Thanks in advanced. Glenn O