-
Images
- 8 replies
- 1223 views
- Add Reply
- 0 replies
- 433 views
- Add Reply
- 7 replies
- 672 views
- Add Reply
- 1 reply
- 950 views
- Add Reply
loose parts from 87
By doobie360,
have some lose parts laying around form an 87 i sold have drive shaft, intake manifold, distributor, valve cover, il pan, stick turbo fan is eat up and bearings bad, maf sensor(i think), also habe some transmission parts hats all i can think of off the top of my head, i will add things tomorrow that i have forgot if any, ALL PARTS SOLD AS IS THEY ARE USED AND DO NOT KNOW RUNNING CONDITION.... BUYER PAYS SHIPPING PAYMENT VIA PAYPAL ONLY!! TEXT 3362253053 IF NEED BE CAN SEND BETTER PICS VIA TEXT
92mm je forged pistons
By doobie360,
have a set of used 92mm je performance forged pistons dont know compression ratio, i had got a mic measurement on them when i had the carbon build up cleaned off, but i dont remember the exact measurement it was 91.8 something something , also have rods from 87 conquest tsi 2.6 but no rod caps ( so they are junk from what ive been told) that will come with them, rods would make good paper weights or something. pistons are used mileage is unknown BEING SOLD AS IS 250 firm! best way to contact is
ok dropped tank to check pump and crank signal ....
By markhansenconquest,
Tank is half way down....pump is out ...hooked up to battery and works...checked when in car 38psi at engine bay filter...Can pump be 38psi and not be strong enough to start car??(car will run after starting with fluid )...will check for power to pump when cranking with light tomorrow..........hard to check for signal and turn engine over at the same time ..........ha ha.........looking at pg 14-26 and 14-27 FSM 86...checking ECI system ....will be doing tomorrow...... any ideas???
tail of the dragon meet
By jaytaylor,
Hey I just moved here from Detroit (drove my 86 quest) I would like to cruse the tail of the dragon would like it if there was more than one quest.
