TsiRacer

Yes its functional.. I think its diffrent and looks cool. I may be in the market for one.

Hey found this cool vent....Would look good molded on. I think it works with the pressure zones on the car. http://www.raretrick.com/store/images/prod...6641_detail.jpg

Cut it out and make a small fill patch will some thin steel sheet metal and weld it in place.

How much for a box for two tens. Infinity perfects, so they dont need alot of room. I have them firing up at the window but would like a box that is rectangular and can be pushed against the rear seat firing the subs towards the rear lights.

Wow nice. Ive thought about going with a 302. Is it a lot of work? Minus all the steering setup you did. Just motor drop in and tranny. I guess I would also need a computer from the donor car with the motor if I go Fuel injected.

Thank you very much! ;D

If you can find a deep enough pool, Ive seen people weight the peice down and submerge it for a few hours or days. The pressure seems to help it stay tight.

Man I still get the " this page cannot be displayed" crap. Can someone post the pics, I am very much considering a v8 swap and would like pics.

Linkie no work! ???

I think you need to put the CF under some vaccum source to keep the weave tight as it dries. Cool idea and if it looks good you will have alot of buisness. ;D

Nevermind I know exactly where that is. ;D

wow not bad at all! Is that the wheel connection over by the big genie car wash on lamar?

how much did they charge for the wheel polishing?

I believe it was an 88 GTA Â ??? They look like the headlight assembly, But I have seen this on an 84 on to 88 TransAm.

maybe a less 235 or 225 / 35 , up front would keep them from rubbing the spring?