Leaderboard
Popular Content
Showing content with the highest reputation on 10/11/15 in all areas
-
It has to be where the holes are drilled. Remember to measure twice, drill once. I would get tape of some kind, tape the strut in place against the shock/strut tower and lower the hood. If it bows move it back or forward and retape. Once you find a spot it doesn't hit or bow then Mark it and check the difference for what the instructions say.1 point
-
Local to the east coast =D. I'm in NY1 point
-
They should be the same. If you didn't know it, the stock turbine housing is the worst design there is. They aim the wastegate flow right squarely into the flow out of the turbine shaft. Can't get any worse than that. Ideally they would never recombine. On most they do it in something they call the 02 housing but that's still a cheap compromise. Some just have an open dump.1 point