CaliConquestAlex Posted May 9, 2013 Report Share Posted May 9, 2013 I picked up a Mookeeh/MK1 oil pressure gauge w/sender and I'm having issues getting it to work properly. I also have their coolant temp gauge and that works perfectly. The oil pressure gauge is wired up the same as my coolant gauge, i.e. same 12V feed and ground, and it will turn on when I put the key to run, but when I start the car, it seems like it's losing power and it's not getting any reading from the sender. I have the sender screwed into the block port right behind the timing cover. Is anyone else running this gauge that can comment on whether or not you're having success? I still have the stock gauge connected and it is reading above 3/4 when cold and then it settles down to below 1/2. Link to comment Share on other sites More sharing options...
Shelby Posted May 9, 2013 Report Share Posted May 9, 2013 you can get a bad gauge,, in fact I've had almost as many bad ones as good ones Link to comment Share on other sites More sharing options...
CaliConquestAlex Posted May 9, 2013 Author Report Share Posted May 9, 2013 I've reached out to the seller on ebay, hopefully he can get me a replacement. I really don't want to have to spend another $50 on a replacement gauge just because I received a defective unit. Link to comment Share on other sites More sharing options...
psu_Crash Posted May 9, 2013 Report Share Posted May 9, 2013 If you bought the gauge from 101Propose I wouldn't worry. He has always been great when I had problems with his products. Link to comment Share on other sites More sharing options...
Goddard Posted May 10, 2013 Report Share Posted May 10, 2013 Can you take a pic of where you put the sender? You may not have it in a place that is pressurized. Link to comment Share on other sites More sharing options...
Recommended Posts