Toyotagt1 Posted August 21, 2012 Report Share Posted August 21, 2012 (edited) i took my g54b to get machined for the rebuild im doing and when i got it back there was 2 allen head plugs that came off the block somewhere i found out the bigger one goes on the back of the engine but when i try and get it tight i cant get to flush with the block will that be a problem and for the smaller one i cant find where it goes i have been looking everywhere in the forums and online and i have checked every square inch of the block and no luck can anyone tell me where the small plug goes its driving me crazy i would really appreciate it thanks Edited August 21, 2012 by Toyotagt1 Quote Link to comment Share on other sites More sharing options...
JAinsworth Posted August 21, 2012 Report Share Posted August 21, 2012 Passenger side, above the oil filter and close to the timing cover.Jimmy Quote Link to comment Share on other sites More sharing options...
Dad Posted August 21, 2012 Report Share Posted August 21, 2012 And the plugs that come in kits are standard pipe plugs, you should reuse your old plugs since they are BPT thread, otherwise you could tap them deeper with NPT taps and use the new plugs.. Dad Quote Link to comment Share on other sites More sharing options...
Toyotagt1 Posted August 22, 2012 Author Report Share Posted August 22, 2012 thanks guys thats what i needed to know and yes very good idea for useing the stock ones they worked just fine now i dont have to worry about an oil leak thanks once again guys Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.