Jump to content

    my MPi as of today

    Shelby
    By Shelby,
    it's  been years in leading up to this point and many hours and lot's of diff  major  changes, some of the items are ,  port'd 20g,  284 cam, 700 cc  inj's , bosh CIS  fuel pump,  42lbs base  fuel pressure, BOV,  hard pipes, intercooler , 4 spd quest auto,  3.90 rear gears , Hawk ecu ,  aftermarket  trans cooler, 2.5 exh full   deff a little faster then it was stock  ;D  

    will the flatside door fit on the later model wide

    FasterTheBetter
    By FasterTheBetter,
    will the flatsiders doors fit on the later model widebodys i have a damged door from a tree and would like to know i can get a door for $50 but its off an 85 i think i know the hoods fit dont they cause i found a hood for 50$ too

    Pics are now up check them outs

    88flipstarion
    By 88flipstarion,
    Hey wassup everybody I just bought a Mitsubishi Starion last sunday like 3 days ago and yesterday I took out the motor because I'm rebuilding the whole block and upgrading the fuel to MPI setup. I took many before and after pictures. My project will most likely be done by next week w/ the setup. Could someone tell me what picture code site can be load on this page like photo bucket etc.? The motor is completely out and me n kenneth disaseamble the head, block, transmission, clutch, alternator, b

    turbo actuator

    claurance2
    By claurance2,
    I want to find out how to hook up vaccum lines to a triple port actuator.

Portal by DevFuse · Based on IP.Board Portal by IPS
×
×
  • Create New...