Jump to content

    RC Engineering Example Data

    Munra
    By Munra,
    I am a newbie when it comes to anything with my conquest. I know I had fuel system issues because the car sat 8+ years with fuel in it. Almost every post I read here said send the injectors RC Engineering. I did, and like to show other newbies the information you get after they return the injectors. Now I wish I took before pictures, but I didn't but they look brand new now. I will post the after pictures this evening.     Also any experience users who can comment on what is the most import

    86 quest idle problem

    Amonje123
    By Amonje123,
    Ok I'm been driving my 86 for about a year now and I'm started to hav idle problems wen i start my car in the morning. Ok so I start it up running great the vacuum gauge I installed shows -15 then after a while it will go to -10 and my car starts idleing rough, black smoke out tail pipe, smells like gas. If I hit gas pettle or turn off car and restart it well go back to normall. It will only do this wen it's cold never warm. I figure it's a week sensor. My car is completely stock, all I've done

    88-89 LSD hubs, and axles

    DieHARDmitsu.
    By DieHARDmitsu.,
    hey all, I'm looking to buy a good, complete 88-89 LSD(differential), 6 bolts axles and hub. If the axles need rebuilding, that fine. Iocal pick up preferred but will settle for shipped depending on the price.   thanks

    Pop ups

    MetalRob
    By MetalRob,
    So in the cold weather (50 or below) the headlamps were taking a couple of minutes to open till eventually one night they took 20 minutes to open up and remained in the open position over the next few days. I checked the fusible link, gets warm but the lights still come on, cleaned that up. I then disassemble the pop up switch & headlight switch cleaned that all up & re-applied some dielectric grease. I think the previous owner had been in there some time ago. Once I put everything back

Portal by DevFuse · Based on IP.Board Portal by IPS
×
×
  • Create New...