wanted ovcp with or without blow off valve....

Are the OEM front and rear offsets different for the StarQuests?   I was searching through "The Official SQC Wheel Thread" on here, and came upon people who don't use wheel spacers for their front wheels, but for the rear wheels, when using wheels with positive offset.   Also, what size spacers would you recommend using for these dimensions if I wanted to go flush?   18x8.5 +24 (front) 18x9.5 +25 (rear)   Thank You!

I've decided to pull the factory harness out of the car so I can eliminate any pieces I don't need. Im going to use the fsm as a guide, but I'd like to get input from others who have done this and who can provide any tips.

How to Clean a Head Gasket Surface   There are many ways to clean a head gasket surface. This is just one way, and it is the method I prefer.   I do not like the use of “rol-locs” for cleaning a head gasket surface, for block or head. Cast iron or aluminum.   This is for COMPOSITE Head gaskets, Not MLS   MLS Head gasket surfaces need more prep.   A rol-loc can an will “wave” a gasket surface when used improperly. In most cases it is.   So do not use this!! http://i261.photobucket.com/albums/ii49