http://i1187.photobucket.com/albums/z388/starionkiller/th_2012-05-23142318.jpg   Plus a spare fan motor bonus.. http://i1187.photobucket.com/albums/z388/starionkiller/th_2012-05-23152050.jpg   $25.00 plus shipping

I finally had time to go back to Va to fix my car and bring it back to Pigeon Forge with me. I didn't realize how much I missed it until I started driving it again! It will take days to get it clean again...lol!

Can't believe I'm doing this but just lost my desire to do this. Don't really have a swap candidate anymore and no heart to hammer or cut the tranny tunnel in the Gold widebody. This thing is REDICULOUSLY clean across the board.   Engine was a low mileage JDM that developed a valve-stem seal leak and got a full head rebuild and bottom-end re-ring and bearing replacement. OIl pump, water pump, etc was also replaced. Toyota factory stuff not auto parts specials (and this is CRITICAL with the b

How to check piston to deck clearance The subject is a Toyota 2ZZ The block is being milled to ensure a good gasket sealing surface. The short block must be dry assembled with crank, rods, and pistons. Rod and main bearings are installed, and only the 2nd ring installed. The tools used are a dial indicator and bridge stand Now zero the dial indicator on the block with .100 preload. http://i261.photobucket.com/albums/ii49/BogusSVO/How%20to/how%20to%202/DSCF4412.jpg Next slide the dial