I'm somewhat new to cars, so please bear with me.   Just last week my brother and I installed a new Walbro 255lph hp fuel pump, along with all new fuel filters. I also bought a new Blaster 2 coil and a new set of ignition wires. The car was running fine before the factory fuel pump went out and we added the new coil and wires. The problem is now that when we try turning the car on, the engine starts up normally but immediately afterwards it starts wanting to shut off and I have to keep pumping

http://i212.photobucket.com/albums/cc82/chipleeiii/DSCN1547.jpg http://i212.photobucket.com/albums/cc82/chipleeiii/DSCN1556.jpg

My voltmeter needle fell off Asking if installing aftermarket gauge in that same location is a pita or if there are any writeups on how it's done. Thanks.

I NEED PRIMARY AND SECONDARY!     PM ME!