My gaskets looked like crapola so I needed a fix.   I scanned and pathed out on my PC my actual crappy gasket, and I made a template for these and I used an engraving machine at work to cut it out of PVC. Then, after tons of searching, I purchased some material that was a pretty darn close match to the closed cell rubber foam that Mitsu used (but this is a tad denser, which is good). After spending about 1.5 hours making them look good, I think I came up with a viable solution (until I find a ma

http://jalopnik.com/5963503/forgotten-cars-anyone-remember-the-time-amg-did-up-a-mitsubishi   http://img.gawkerassets.com/img/186k69vfotjgajpg/xlarge.jpg

I was at my favorite Sushi joint in Glendale when I noticed they had a new beer in their shelves, Orion! I was like "no way, I gotta have one." So I did.   I wonder if the Mitsu engineers named the Starion after pounding some cases of Orion Beer?   http://i281.photobucket.com/albums/kk226/80sriceman/55C3590B-8468-415E-B73E-E242F534EB4E-1950-000002A55515F3FF.jpg

Hi, just trying to verify that these will work without the cutting and welding. With my upcomming change of station, and lack of knowledge on that kind of work, I want to make sure I am not getting in over my head. Thanks for the help!   http://www.ebay.com/itm/Mookeeh-MK1-Widebody-Starion-Conquest-TSI-Rear-Gas-Struts-Shocks-/160707087837?_trksid=p2047675.m1850&_trkparms=aid%3D222001%26algo%3DSIC.CURRENT%26ao%3D1%26asc%3D11%26meid%3D3852056371677079657%26pid%3D100011%26prg%3D1005%26rk%3D1%