'83 Hood with nice scoops - $250   http://i186.photobucket.com/albums/x313/gtxthunder/SDC14537.jpg http://i186.photobucket.com/albums/x313/gtxthunder/SDC14540.jpg http://i186.photobucket.com/albums/x313/gtxthunder/SDC14539.jpg http://i186.photobucket.com/albums/x313/gtxthunder/SDC14538.jpg     Turbo handles - $45   http://i186.photobucket.com/albums/x313/gtxthunder/SDC14525.jpg http://i186.photobucket.com/albums/x313/gtxthunder/SDC14528.jpg http://i186.photobucket.com/albums/x313/gtxthunder/SDC1

I had the machine shop replace the bearing shaft bearings in my block. (My machine shop calls them bushings)   The upper balance shaft has a thrust plate that bolts to the block. Should any part in in the thrust plate be replaced when rebuilding a motor? Should the thrust plate be taken apart and cleaned? I don't see a bearing in the parts manual for the thrust plate.   Thanks,   Tom

Ok guys I installed my afc and everything works but no rpm signal to the AFC I have it hooked up to green wire from afc to white number 1 yellow plug at the ecu This is a turbo swaped truck with an 88 tsi motor and it runs great just not sure if it makes a difference as to where I install the green wire can I pull it off the negative side of the coil and run it to the afc? Any help is appreciated thanks

Ok, while at the local junkyard trying to pull a 85-6 digital dash (Yard crushed it a few days ago!!!!!!!!!!!!!!!!!!!!!) Somehow I came across a MSD DIS-4 and Boost retard controller.   I could sell them, and make a killing. I got both for $20!   But, I think I could use these for a nice Coil on plug setup, correct? What would I have to do for the stock tach to work, and does anyone see any huge issues with this. (I am very good with mechanics, MECP Master installer, so great with wiring.   I k