I'm Don. Bought my first Chrysler conquest a couple weeks ago. I'm excited about my build!! I have built quit a few 1g dsm's and a lot of other cars. But never a rear wheel drive Mitsubishi. I am a pretty experienced mechanic. I run a transmission shop and build many cars on the side. Not much of a computer guy and I don't use social networking much. But I'm gonna give it my best shot. Mostly because it's harder to find these parts than the 1g dsm stuff. Hope you like what you see. Thanks   1

An old but good write-up on getting an alum. Fidanza resurfaced recently. Old hat for some, but I didn't see it as a sticky, Trans/Clutch/Drivetrain FAQ, or in the Engine & Performance Mods forums.   If the OEM dowel is a bit loose, the 10x24mm Fasenol dowel part # is: 40079 to go into a new hole via a 25/64" drill bit.   http://b2600turbo.com/fidanza_aluminum_flywheel.htm

http://i1355.photobucket.com/albums/q714/Luke_Tainter/Montero/PHOTO_20130415_201701_zps19abf4ed.jpg http://i1355.photobucket.com/albums/q714/Luke_Tainter/Montero/PHOTO_20130415_201711_zpsceab70d5.jpg

When I look up Sarajevo White, it comes up as W18/PW1. Rocky White is also W18...but without the PW1 after it. What's the difference here? I had some parts on my car painted and they don't match. I'm trying to figure out where and who went wrong.