Didnt want to take over the other post so made a new one here. I want to try to make an gustimation map of the stock timing curve.   For discussion sake lets say 15psi   Modifiers:   Vacume advance -7 degree per 1psi How much total advance with vac?   Distributor Weights with 2 springs strenths   Ignitor/Knock Upto -12 when detects knock? With knock sensor dissconnected -8   Colant temp/alt

I have my first R154 drive shaft that I had made. It was meant for a 4g63 swap moved 2" forward so it would most likely have to be shortened. It has a spicer slip yoke for 1310 u joints and stock Mitsu in the back. It's a little beat up from the rear u joints braking on me twice. I paid around $400 to have this made. $100 plus shipping and Paypal fee's

pulled the compressor housing off the turbo and found this   http://www.starquestclub.com/forum/uploads/gallery/album_1127/gallery_7736_1127_7867.jpg   previous owner clocked this turbo and instead of grinding off just enough for the alignment pin to clear, looks like a whole chunk was taken out and the o ring is clearly exposed. its been running this way for over a year w/o problem. would I be safe to reuse it or is it junk?

can anybody tell me if there is a website i could go to for aftermarket parts for a starion...or where to find an aftermarket intake i was lookin on here alil bit but not much luck...thanx