Still has the paper tag on it,,,so not a crap ton of miles on it. Mb325346   250 plus ship/ppfees Paypal note   Note:: paying thru Paypal is for the convenience for the buyer The fees are 3%,,,,a post office money order is 1.00,,,and post offices are located In almost every town in the states. Long story short,,if you don't want to pay with post office money order Or pay the Paypal fees then The deal isnt Doable. I prefer post office MO. Well cash is good but not practical.  

I picked this bell housing up to match up to a 2.4L G4CS block but I just can't seem to find one anywhere near me. I was planning on putting it in my Starion (RWD) but it will bolt up to any FWD 4g63 or FWD 4g64 in a RWD configuration.   This is for an LT1 T56. Because I don't need it any more, this deal ALSO INCLUDES an ACT Streetlite 6-bolt flywheel already bored out for the t56 input shaft and the throughout bearing as shown in the first pic.   This is from Bills Auto Fabrication and you can

Hi Looking for a 1985 or 1986 Black plastic A-pillar interior trim piece in good condition. I converted my interior to the 1986 style without auto belts and this is the one piece from the donor that was cracked and brittle. If you have one, please let me know your price shipped to 93012.   Thanks   Paul

Ok guys I installed a 3" gm maft and and I have. safc 2 As well the problem is I have the afc set to zero and I'm trying To set a base tune with just the maft and fine tune with afc but I can't seem to get it running good on just the maft it will idol good But after that when driving I'm running pig rich and can't seem to lean It out I read through the Great maft settings but that confuse me more A little about the mods. I'm running a 19c and a 52mm throttle body lower shores fuel injectors