OK, this is my recent project for a CHEAP mpi setup for the quest. Keep in mind im ONLY using this for FUEL ONLY.   This is what i have:   '90-94 12 valve geo storm/metro ecms engine wiring harnesses 46lb@33psi (51lb@45psi) fuel injectors (bosch type) 2 bar map sensors all other sensors needed homemade fuel injector pulse controllers   This ecm has only a few errors codes/sensors, so i dont think that it would be put into OPEN-LOOP do to a fault code.     Basically these parts were FR

This is a post by Ed.   Thanks for your excellent info Ed!!! --------------------------------------------------     Posted By: ED Date: Friday, 24 November 2000, at 4:07 p.m.   In Response To: Mike C -Bosch pump wiring help (nix)   To wire the pump, I advise to give the pump a new power circuit. Use terminal #1 on the control relay, located near the ECU, as the energizing power for a good heavy 12V normally open relay. Connect this terminal #1 to the switching contact on the relay. Follow

Im sure most of you have seen the drilled slotted rotors for sale on ebay at some point or another. These rotors are marketed by a company called rotormasters. I recommend to not buy anything from these people, they seem to be scam artists! I ordered my rotors almost 2 months ago and have received nothing from these guys but excuses, in fact they received so much bad feedback on their old ebay id that they switched to a new one. So i repeat do not buy rotors from rotormaster or anyone who sells

MY s*** CAUGHT FIRE!!!!!!!  im coming out there