-
Images
- 3 replies
- 1402 views
- Add Reply
- 1 reply
- 918 views
- Add Reply
- 14 replies
- 775 views
- Add Reply
- 10 replies
- 1918 views
- Add Reply
New head installed now car runs like crap
By flatty86,
Hello Guys, It’s been a while since I been on here as my car has been broken for about a year now. My flatty had a warped head.. Anyway bought a new head and put everything back together. Car runs like total crap. Tried lining up the timing marks and setting the distributor with no luck. Al that did was made me lose power. Can someone tell me what’s going on with this car?. Thank you.
4g64 block 4g63 head swap
By dsm9478,
Hello guys not sure if this is in the right section or not but I have been doing alot of research and I have readon other forums that older mitsubishi 4g64 blocks bolt up to our transmissions and then the 4g63 dohc head bolts onto that I would like to verify if this is possible and how much fabricating is required or if its pretty much a direct bolt.inand then id just have to run wiring and if this is possibly what models and years of mitsubishis can I find the 4g64 block that bolts in because I
towing my conquest via car dolly
By danfev1985,
Hi i'm supposed to be pulling my quest to my house this weekend using a uhaul car dolly. My question is would i have to pull the driveshaft prior to towing, or would just leaving it in neutral suffice? It's 25 miles from pickup to drop off at my house.
Big rig truck question, air brakes and compressor
By questsale,
Question about how the air brakes, compressor, tanks work on a Frieghtliner truck. This has been an increasing issue with this truck, now it will not fill the air tanks and the air brake wont release, so I cant move it. Takes about 30 minutes to get the air tanks to 60psi, almost no power steering, pumping the brake paddle drops 15psi, takes for ever to fill back up. Not sure if the air compressor is bad, clogged, or is there a filter that needs to be looked or inspected? I have no experience
