Ok, here's one.  How about teh ability to be nitified if a thread that you are interested in gets a new post, even if you haven't posted to the thread.  I know that this might be impossible given that you are somewhat constrained by the "stock" capabilities of the yabb system.  But it sure would be nice.

86 TSI:  “A” connector   1: IGN – 2: AFS 3: n/c 4: GND (AFS) 5: Intake temp 6: Coolant temp 7: Idle SW 8: Motor Position SW 9: Pressure to gage 10: +5 volt power 11: O2 sensor 12: Ignitor signal 13: n/c 14: n/c 15: TPS 16: n/c 17: Intake temp (OVCP) 18: n/c 19: speed (coil) 20: n/c 21: Diag. Output 22: control relay (fuel pump) 23: secondary air (for catalyst) 24: pressure solenoid   86 TSI “B” connector:   1: +12V 2: GND 3: GND 4: EGR 5: IGN (cranking)

Here is a step by step instruction for anyone who wants to install the 1st Generation Eclipse (90 thru 94) stereo with CD, Cassette and Amplifier on there StarQuest.   1.   Remove StarQuest stereo system from car. 2.   Install the StarQuest mounting brackets on the eclipse stereo system both CD and Cassette player. 3.   For 87 thru 89 models, remove the (2) screws that fasten the seat belt controller. 4.   The carpet is already cut in the stereo compartment just move the carpet toward both

I'm curious as to how much of a diffrence the larger S/T sway bars made.  Was it a noticeable diffrence.  Worth the money.  Can I get buy with new polyurathane bushings on the bolts?  Any input is welcome. Thaks