Hey fellow 'questers!   I have just imported a set of '89 quest taillights into Australia and wish to do the de-lensing thing.... any hints? Do you warm 'em up in the oven, not too hot so it melts the cover, just warm enough to soften the polyeurathane sealant? What temperature would the be, roughly? (degrees celsius pleeeeze, otherwise I have to do that divide by 1.2, minus 32 thing or whatever, and my brain is just not ready for that!) I only have one chance to bugger these lights up, so a

Hey guys, I bought a 84 Supra hatch shade off of a guy from the boards about 2 yrs ago but never put it on my Quest 'cause I could never figure out how to do it. I see that some of you have done this mod. How did you do it?  I gotta get that thing on there so any help would be appreciated.   Thanks, Jerry

ok, i just recently did my intercooler setup on my car and i must say it turned out better than expected. basically, i used the existing holes behind the headlight motors to get my pipes in/out of the engine bay...  an i even kept the charcoal canister! front http://us.f1.yahoofs.com/users/a71d304f/bc...c04Pg9ANNRDB9IM pass side http://us.f1.yahoofs.com/users/a71d304f/bc...c04Pg9AzUec1BMt drivers side http://us.f1.yahoofs.com/users/a71d304f/bc...c04Pg9AdTSjJ3WX   and i only had to make

Hello everyone, I have a somewhat stock 89 5-speed conquest and I am looking to do some mods that will help it run better and faster.  I dont have a lot of money to spend, so I am looking for inexpensive mods to help it out.  I have already opened up the exhaust and now and experiencing the fuel/boost cutoff at about 15 psi.  What can I do to get that to stop and what other mods can i do??  Any help is appreciated.  Lastly, the motor has about 150k miles on it and i am thinking of rebuilding it