mock1
-
Posts
7 -
Joined
-
Last visited
mock1's Achievements
Newbie (1/14)
0
Reputation
-
what kind of Tolerance should the head Surface be in as far as flatness.? .001
-
see
-
with lube . and are u suppost to tighten them down and losen them to strech the bolts , if so how much. i did not cycle them last time and it was not perty
-
what is the torque on arp rod bolts
-
i am going with forged pistions this time
-
i have a manual and know what it calls for was just wonting to know if that is the best procedure
-
could some one list the best specks to go by while building my engine . any and all will be greatly Appreciated. would like all clearances on motor and any tork value
