Jump to content

    cheap intake exhaust manifold

    Guest c89zx7r
    By Guest c89zx7r,
    has anyone thought about getting a adapter made so you can use a extra intake as a exhaust manifold ? just cut off all the ports and thermo housing side and weld them shut or block them off ? would be a cheaper way for a better manifold . since the intake has better bends in it should flow alot better . might also loose some lag .

    Switch panel finally installed..pod fixed...

    Adi
    By Adi,
    I finally finished my switch panel...Came out looking real nice...it was my first and needs to be done again...Which I still have the materials...So I may make it a bit nicer and find a better way to bolt it in other than super glue...But here is what it looks like.  I made a true wire harness for it was well to run under teh comsole peice that houses the seatbelt release and power mirror switch...funny thing is I made the harness too long so I have lotsa lotsa extra wire to play with..lol..  

    Aftermarket Seats.......

    csdisme
    By csdisme,
    Just wondering who has aftermarket seats and what kind?? Kind of had my eye on the Tenzo but was wondering if they would fit?? Especially side to side.....   Also, anyone using harnesses, where did you tie them in??   Thanks for the input...  ;D   Cullen

    got a lead on carbon hoods

    Quest4Power
    By Quest4Power,
    i found a local guy here in atlanta that would do them... but he wants $1000 up front for each one  > if anyone is willing to put up the dough so he can make a mold let me know and i'll put you into contact with him.  he said they'd weigh between 9 and 12 lbs, full carbon fiber (no fiberglass).

Portal by DevFuse · Based on IP.Board Portal by IPS
×
×
  • Create New...