Does anyone know the wire setup for a aftermarket radio?.... I want to install a new head unit on my 87 conquest but I don't have the harness I just want to hard wire it...I've been looking everywhere for a diagram of some kind that would tell me...but I've had no luck in finding one...

Stock http://63.251.78.219/Image%20file/Shop/DSC00163.JPG Ported http://63.251.78.219/Image%20file/starquest%20mods/DSC03570.JPG Used a file to port it, some sand paper, and Steel whole. Going to Use this on the monty

I printed out quite a few pages from the online repair manual, but are there any special tools to get the tranny down and out of the car to replace the clutch?  Certain cars have certain procedures and I want to make sure I know what's goin on before I go and replace this in the garage next week (I hope).  I've already done a FWD clutch before so I hope I can do this without too much trouble.   Thanks in advance!

Im pulling 1600 degrees, in 3rd an going to forth.  Has anybody really started tiuning, thiers yet.  I talked to robert at forced, an he said that sounds about right.  But the equation for sounding "about right".  has me wondering.  It still pulls pretty good,. untill i overrev it to death, playing with this thing.  maybe i should just go an throw this thing on the dyno.  any opions,. please.     thankx