I need some help identifying the ports on the wastegate actuator in order to complete the installation. #1 taps into the third port(on the throttle body) where I get the signal for the BOV. No problem here although the boost gauge and the RRFPR all receive their signal from this port. Am I "taxing" this port?   #2 connects to a source of pressurized air (the discharge side off the compressor housing of the turbo or compressor outlet pipe) before the intercooler. I can't place a port to tap int

This is for Shawns adjustable cam gear   http://63.251.78.219/sqi/Adjustable_Cam_Gear.htm   5 gears+   - $195.00 10 gears+ - $185.00 20 gears+ - $175.00 30 gears+ - $175.00 - *** Shipping included ***   If your in for the GP then reply.   If you have ANY other questions email shawn starconquerindustries@shaw.ca   Again do not reply to this thread unless you want in on this GP. Questions will be deleted.   Deadline is TBD. Would be nice to get a quick count and get them out to us.

Does the 3000GT caliper"Mitsubishi" fit in our car, if so what years? thanx They'll look nice....

I am settign up plans on a drag engine.  I am thinking T-66, or soemthing around there (or might stay mitsu 25G) .     Full prepped block. O-ring, .060 over, all the bearing journals re done, usual BSE, teflon coated cyclinder walls   Then shot peened rods, JE or ARIAS inside, Clevite bearings, SCE copper gasket, marnal head, custum ground cam ( 292 int dur, 294.5 exh dur, .49 lift both int&exh, 110.5 deg sep) 3-3.5" exh, full 15k  balanceing   MPI(hawk management) (either Glens or EIP