Looking for an 88-89 Quest in decent shape. Can spend $2000-2500. Somewhat close to Greensboro NC would be nice. Thanks

This is how we prime an engine after rebuild.   You may want to get one of these if you do quite a few engines, or make you own   Here is the tank. http://www.enginemachineservice.com/prime2.jpg   We attach the hose to the front fitting of the block....       http://www.enginemachineservice.com/prime4.jpg   http://www.enginemachineservice.com/prime1.jpg     The tank is filled with oil then pressurised to 100-120 lbs shop air. There is a valve on top to release the pressurised oil..

Just a spot to post pics of your starquest(or whatever else you're working on) and any mods and whatnot. That was one of the things I was kinda dissapointed with when I was trying to do some reasearch. I had to scrape around for pics. I figure if you just make a forum for it, people will know where to go to find pics!   Just a suggestion! K!

Need a good torque tube, i.e. one that the teeth are still trapezoidal and not worn down to a point. BAD Note splines very worn. http://www.we-todd-did-racing.com/wetoddimage.wtdr/wMTIzMzEwNjZzNDEzZGZkMzF5NTQx.jpg   GOOD Note the trapeziodal teeth. http://www.we-todd-did-racing.com/wetoddimage.wtdr/wMTIzMzEwNzZzNDEzZGZkMzF5NTQx.jpg   HELP!!!!!!!!   ADAM[/img]