Jump to content

    Happy Birthday Starfighterpilot!

    NikoFab
    By NikoFab,
    Have a good one Ken!

    Oil leak around knock sensor

    questsale
    By questsale,
    I have an oil leak around the knock sensor. Does it pass through an oil passage, or should I look elsewhere?

    blown head gasket or piston land/ rings

    Amonje123
    By Amonje123,
    Ok I'll make this short and quick. I run a 17c at 20psi. Dads njv head S's valves. Went to this setup about 5k 6k miles ago. I went on a fun run late last night. Running it hard. Had it up to 140 mph. Got home notice a miss. Check the car today after work. Had oil in all ic pipes and intercooler. Cleaned it all out. And restarted it.Car smokes out of oil separator wen running and oil dipstick if pulled out. Guessing alot of blowby. Pulled all plugs they looked good no oil. Did a hot compression

    Wire harness

    tsi_tom
    By tsi_tom,
    88-89 Wire harness needed. Not sure if an 87 will have the wire color codes.   I need to repair some of the brittle wires that have snapped in the engine bay by the throttle body. I plan to use some of the wire under the fender to replace the brittle stuff by the throttle body.

Portal by DevFuse · Based on IP.Board Portal by IPS
×
×
  • Create New...