Jump to content

Leaderboard

Popular Content

Showing content with the highest reputation since 11/01/26 in Posts

  1. Sounds a lot like a grounding issue to me. How did you even discover this? Trying to diagnose the non-functioning wipers? Did the wipers suddenly quit working? Have you noticed anything else that doesn't work with the wiper motor unplugged? I would take a look at the wiring schematic to see what shares a ground with the wiper motor to start with. I don't remember if the wiper is switched gound or 12V. Tomorrow I'll try to remember and take a look at the schematic myself too.
    1 point
  2. That sure is strange! Just started? Did you do any work recently? I won't say I had your problem but I had something similar enough to share with you just in case. I had a bent pin in a connector above the ECU. I'll take a pic tomorrow. It was no crank and I know this harness includes some wiper wires too.
    1 point
  3. It's been a few weeks and everything is back. Time to reinstall. (I picked up an old TEP rear strut bar over the winter that also got powder, that'll wait to be installed till another day though) Here's a closer up of the powder. New sway bar links and sway bar bushings. I started with the rear. Then I moved on to the front. Looks super good, can't wait to feel how much of an improvement this will make with handling. 30 year old components were toast, this was long overdue. Here's where we sit with just a few more weeks till the weather turns.
    1 point
×
×
  • Create New...