87starion_in_ma Posted August 10, 2009 Report Share Posted August 10, 2009 i'm installing a 60-1 and i need to know what other people have done to plug up the old oil drain thats in the timing cover. Link to comment Share on other sites More sharing options...
BOOSTED88tsi Posted August 11, 2009 Report Share Posted August 11, 2009 I have a front cover off my truck that doesnt even have the that bung in it. 25 shipped to you. Link to comment Share on other sites More sharing options...
87starion_in_ma Posted August 11, 2009 Author Report Share Posted August 11, 2009 the problem is the motors all together and in the car and the time cover thats on there was decked with the block Link to comment Share on other sites More sharing options...
JustPaus_88TSi Posted August 11, 2009 Report Share Posted August 11, 2009 Hose clamp a bolt in a short section of the old drain hose? Large vacuum cap? Does the 60-1 hang too low on a different manifold, making you use the oil seperators drain location in the pan? Link to comment Share on other sites More sharing options...
Edde Posted August 11, 2009 Report Share Posted August 11, 2009 Don't know if you can match up one of these? http://www.aerocorsair.com/6fc6c110.jpg Link to comment Share on other sites More sharing options...
ucw458 Posted August 11, 2009 Report Share Posted August 11, 2009 i'm installing a 60-1 and i need to know what other people have done to plug up the old oil drain thats in the timing cover. Go to home depot, or whatever home improvement store near you and get a 1/2" threaded brass pipe plug. The hose barb on the timing cover for the oil drainback comes out. Just remove it and put the 1/2" plug in. Use some sealer on the plug. Link to comment Share on other sites More sharing options...
87starion_in_ma Posted August 13, 2009 Author Report Share Posted August 13, 2009 Hose clamp a bolt in a short section of the old drain hose? Large vacuum cap? Does the 60-1 hang too low on a different manifold, making you use the oil seperators drain location in the pan? yes i'm useing treadstone manifold. i welded a -10 male fitting to the oil pan. Link to comment Share on other sites More sharing options...
Chad Posted August 13, 2009 Report Share Posted August 13, 2009 Go to home depot, or whatever home improvement store near you and get a 1/2" threaded brass pipe plug. The hose barb on the timing cover for the oil drainback comes out. Just remove it and put the 1/2" plug in. Use some sealer on the plug. ^ That is what I'd do too. Link to comment Share on other sites More sharing options...
Recommended Posts