ghinckley68 Posted August 23, 2015 Report Share Posted August 23, 2015 just goes to about a 1/2 or so of the end of the travel till it engagues it works but it just did all at once. any clues Link to comment Share on other sites More sharing options...
nightwalkerancestery Posted August 23, 2015 Report Share Posted August 23, 2015 Check the good ol pivot pin where the master cylinder connects to the pedal under the dash. Could have had the pin get side ways or come out partly or just so much play that it's angling the rod. Check that and then take it from there. At the least, you won't hurt it by checking, fixing that point. - Charles Link to comment Share on other sites More sharing options...
ucw458 Posted August 23, 2015 Report Share Posted August 23, 2015 Bad master/slave or broken clutch fork. Link to comment Share on other sites More sharing options...
importwarrior Posted August 23, 2015 Report Share Posted August 23, 2015 I Agree with ucw. Usually a bad slave. Masters are generally good but slaves seem to go bad a,lot faster. Link to comment Share on other sites More sharing options...
ghinckley68 Posted August 25, 2015 Author Report Share Posted August 25, 2015 the fluid in the resivour was empty Link to comment Share on other sites More sharing options...
importwarrior Posted August 25, 2015 Report Share Posted August 25, 2015 probably leaking out the slave cylinderslide under the car and pinch and or move the rubber sleve on the slave cylinder and see if fluid drips out. you do not want to get stranded somewhere. Link to comment Share on other sites More sharing options...
ghinckley68 Posted August 25, 2015 Author Report Share Posted August 25, 2015 i did that but no. but that was my first thought and the fluid level is going down a litttle every day so just going to get a new one and put it on its. that one is the factory one i am sure. Link to comment Share on other sites More sharing options...
ucw458 Posted August 27, 2015 Report Share Posted August 27, 2015 Clutch master tends to leak inside the dash. So it can be hard to spot a leak. Link to comment Share on other sites More sharing options...
ghinckley68 Posted August 27, 2015 Author Report Share Posted August 27, 2015 I am going to rplace both and the hose and just nipp it all in the but at one time. Link to comment Share on other sites More sharing options...
Recommended Posts