DMNDSTAR87 Posted May 18, 2014 Report Share Posted May 18, 2014 (edited) http://i1125.photobucket.com/albums/l587/dmndstar87/Mobile%20Uploads/image_zpsf91f3250.jpg} I heard when running the adjustable version that the tower had to be trimmed to get full range of adjustment... But as seen in my pic i run the nonadjustable ones and the motion is limited because the topnut is hitting the opening in the strut tower..Gig out Edited May 18, 2014 by DMNDSTAR87 Link to comment Share on other sites More sharing options...
87B71Brad Posted May 19, 2014 Report Share Posted May 19, 2014 That's how mine looked. I took my large carbide burr bit and notched that sucker out. Had to enlarge it big enough to let washers rest on the plate. Im tucking 225/50 now..lol If you want a pic of mine lmk Link to comment Share on other sites More sharing options...
DMNDSTAR87 Posted May 19, 2014 Author Report Share Posted May 19, 2014 That's how mine looked. I took my large carbide burr bit and notched that sucker out. Had to enlarge it big enough to let washers rest on the plate. Im tucking 225/50 now..lol If you want a pic of mine lmkPlease do...ThxGig out Link to comment Share on other sites More sharing options...
dmyers151 Posted May 19, 2014 Report Share Posted May 19, 2014 Did mine like this:http://i471.photobucket.com/albums/rr71/dmyers151/0520091336a_2.jpgIf I recall I used a Dremel and a few cutoff wheels. The metal is sandwiched there 3-4 layers thick there. Link to comment Share on other sites More sharing options...
DieHARDmitsu. Posted May 19, 2014 Report Share Posted May 19, 2014 (edited) Try Rotating the camber plates 180* Edited May 19, 2014 by DieHARDmitsu. Link to comment Share on other sites More sharing options...
87B71Brad Posted May 20, 2014 Report Share Posted May 20, 2014 http://i1325.photobucket.com/albums/u626/gtxbrad/Mobile%20Uploads/IMAG1619_zpsou9phbpf.jpg Im using the non pillow type tho. So your cut could be smaller to just allow nut to move instead of requiring washer like mine. Link to comment Share on other sites More sharing options...
psu_Crash Posted May 24, 2014 Report Share Posted May 24, 2014 My Mookeeh plates are right against the sheet metal too. Although I must have got lucky and didn't have to trim/bend anything since the flats ended up in the right spot Link to comment Share on other sites More sharing options...
KT Posted May 30, 2014 Report Share Posted May 30, 2014 Try Rotating the camber plates 180* ^This Link to comment Share on other sites More sharing options...
Recommended Posts