Jump to content

1988 Modded CONQUEST OR STARION $6500


matt88
 Share

Recommended Posts

Sold sold sold sold -------------------------------------------------------------------------------------------------------------------------------------------------------------Ok I'm selling my baby!! It is a 1988 Chrysler Conquest. The car has about 400+ HP and is an amazingly powerful car. I have so much done to it that I'm sure I will forget to mention something. I'm asking $6,500obo. and I have at LEAST $15,000 invested into it. If you are a fan of the type of car this a GREAT deal. This car has been garage kept and very well maintained over the years. Below is a list of the mods. If you are interested please call me/Matt @5085252399 Also I have many spare parts and possibly a parts car that that may go with it. See pictures at bottom!! Here is a link to a video of the car also

Also Craiglist AD

http://boston.craigs...2872310619.html

 

Engine:

Wisco Pistons (6cc dish 8 to 1)

Race prepped rods

Balance shafts eliminated

Clearwater non jet valve head

Ported head and matched to intake and exhaust manifold

Top End Mechanical Cam

Ajusa Metal Shim Head Gasket

ARP Head Studs

Knife Edged Crank

Heavy Duty Valve springs

South Florida Performance exhaust manifold

60-1 Garret turbo with Blanket

HKS external wastegate

Fuel Injection Pros MPI intake kit with their stand alone ecus

AEM fuel pressure regulator

New Oil Pump

New Timing components

Fidenza Aluminum Flywheel

New Engine Mounts

Mitsubishi labeled Valve cover

CX Racing Aluminum Radiator with Dual Fans with custom aluminum shroud and adjustable temp fans

MDS 6al box and MSD coil

MSD 2 Step Launch Controller

New Large Front Mount Intercooler

All Hard Pipe Intercooler and with 4 ply couplings with T bolt clams

AC Delete with proper bracket

New Water Pump

New 8.8 Spark Plug Wires with heat sleeves

New NGK spark Plugs after Tuning

TEP 500 + HP Bosh Fuel Pump with new lines/6an etc.

2.5'' exhaust straight to a straight through muffler

All new hoses, fitting, gaskets and every bolt in or on engine was replaced (seriously)

 

Drive Train:

ACT 6 Puck sprung clutch with ACT Extreme Pressure Plate

New Tranny Mount

New Poly Rear End Mounts

 

Suspension:

Suspension Techniques Lowering Springs

Tokico Struts on all 4 corners

KMAC Camber/Caster Plates in front

Suspension Techniques Anti Sway Bars with poly bushings

 

Brakes:

Cross Drilled and Sloted Rotors

4 New Calipers painted red

Stainless Steal Braided Brake Lines

New Hawk Brake Pads

ABS Deleted With SS Braided Line

New E-brake cables

 

Wheels:

Stern Wheels 18x9 Front 18x10.5 Rear Staggered but can't remember exact offset

4 Billet Aluminum Hub Centric Spacers

New Tuner Lugs

Tires are Maxxis and are great for street/show/drift

Also have Mickey Thomson Slicks on aluminum American Racing wheels

Also Spare Starquest wheels

 

Interior:

Monaco seats

Manual Seat Belt Conversion with MSD 2 step in coin tray

FIP ecus mounted in glove box

Autometer Tach with Shift Light

AEM Wide Band

Autometer Boost gauge

Dual Gauge pod

 

Stereo:

Pioneer Double Din Head unit with CD/AUX/Tape and EQ with built in DSP crossovers for all outputs

M-Audio amp

Boston Acustics Components in doors

Boston Acustics 2-ways in rear

Battery relocated to hatch on Passenger side

Optima Battery with warranty

2 Kicker Solo Baraks Subs 12"

Built in Battery Tender

Taylor Battery Shut off Switch (behind rear plate)

 

Body:

Tinted Windows

Custom Hood

Custom Side Scoops

 

Misc. Parts not Installed

Factory Mud Flaps

Factory 1983 Hood

SHP Wheel Set

Factory Louvers

Tan Factory Floor Mats

Also possibly a whole parts car

 

The Bad:

Will need body refinished to be perfect. As you can see in pics the body is in very good condition for the age. The body is the only thing I haven't completely done over. Also will need a Half Shaft boot (it's torn)

 

I probably am forgetting things but that's the best list I good come up with all at once.

 

Thanks for looking!!

Matt

Edited by matt88
Link to comment
Share on other sites

Wow, that is ALOT of car and parts for the money. I think this is the deal of the year for sure. Lots of MPI cars coming up latly, makes me consider buying one done instead of finishing my life long project.
Link to comment
Share on other sites

Yeah maybe we should. let me know if you know others also. Where you from, I'm from the Fall River New Bedford area.

 

I really don't know anyone else in Massachusetts.......I am in Natick/Boston area

Link to comment
Share on other sites

This seems like a very nice car for the price, it's obvious you have a lot of money invested in it. How many miles are on the engine and how many are on the body? Is this a rust free car? It looks good, just wondering about the mileages.
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
×
  • Create New...