25gconquest Posted August 13, 2011 Report Share Posted August 13, 2011 Hello Bill this is Conrad who had sent you the pictures of the bell housing I had made using the front of the automatic tranny. I had to use an internal bearing and constant having it fail I am sitll using stock fly wheel and pressure plate with a custom 240mm clutch for the 26 spline center .I had act made a part number for this clutch.(I apologize for the delay. R&D has finally got back with me. We can make the disc. Here are the details-The 6240320 Retail price @ $181.75.We can start the process if you would still like the disc. Please let me know.Dean Williams Sales and Customer Service Supervisor) I will purchase a bell housing if you do one for the wide block to t56. Link to comment Share on other sites More sharing options...
Bill Hincher Posted August 14, 2011 Report Share Posted August 14, 2011 ohhhhhhhhhhhhhhhhhhhhhhhh geez, I cant let you down Conrad, you been more then fair Link to comment Share on other sites More sharing options...
25gconquest Posted August 15, 2011 Report Share Posted August 15, 2011 I will need one soon after I finish my restoration I dont want to go back with the old setup every time I have to replace the internal bearing I have to lift the engine and that is about every 3 to 5 k it is no fun. Link to comment Share on other sites More sharing options...
Recommended Posts