importwarrior Posted September 22, 2014 Report Share Posted September 22, 2014 (edited) in this pic below, any one running a Magna use these 2 sensor locations? do you now the thread size? http://i139.photobucket.com/albums/q299/I-W/M%20P%20I%20project/mpi-sensors_zps31871792.jpg Thanks, Edited September 22, 2014 by importwarrior Link to comment Share on other sites More sharing options...
ucw458 Posted September 22, 2014 Report Share Posted September 22, 2014 pic not working But from memory, the only OEN location is below the Tstat on the bottom. The stock temp gauge threads in there. All the other threaded holes were put there by whoever modded it so they are probably pipe thread. Link to comment Share on other sites More sharing options...
importwarrior Posted September 22, 2014 Author Report Share Posted September 22, 2014 (edited) Sorry possibly right click and open in new tab or window. it might possibly be 1/8 NPT. but i wanted to make sure it is not metric. i had to drill mine open. the threads could be seen when looking in the tstat hole.but the bottom was flush and flat. as if it was welded shut - ground flat.if you didnt look close you would not see it on the bottom. http://i139.photobucket.com/albums/q299/I-W/M%20P%20I%20project/mpi-sensors_zps31871792.jpg Edited September 22, 2014 by importwarrior Link to comment Share on other sites More sharing options...
ucw458 Posted September 22, 2014 Report Share Posted September 22, 2014 (edited) Try hosting pics on a different site. Error 1011 Ray ID: 16e0ee780a0f0691 Access denied What happened? The owner of this website (www.4x4wire.com) does not allow hotlinking to that resource (/mitsubishi/tech/turbo_monty/picture.jpg). Edited September 22, 2014 by ucw458 Link to comment Share on other sites More sharing options...
importwarrior Posted September 22, 2014 Author Report Share Posted September 22, 2014 (edited) thanks for the help and sorry for problems. i believe i fixed it. i hope it is 1/8th NPT i will have to test it once i get an 1/8th npt to test with.. Edited September 22, 2014 by importwarrior Link to comment Share on other sites More sharing options...
CaliConquestAlex Posted September 23, 2014 Report Share Posted September 23, 2014 I think it's 3/8" NPT. That's what my magna has. That's the thread pitch for the GM CTS. Link to comment Share on other sites More sharing options...
ucw458 Posted September 23, 2014 Report Share Posted September 23, 2014 That's 3/8" and that T is gonna hit the AC compressor. Link to comment Share on other sites More sharing options...
importwarrior Posted September 23, 2014 Author Report Share Posted September 23, 2014 thats not mine just using that pic so you would know what i am talking about. Thanks for the help., Link to comment Share on other sites More sharing options...
Recommended Posts