The rear shelf is made of pressed board with carpet on it. Mine broke in the middle and sagged down. I thought about taking the carpet off and fiberglassing the break. That would be a real pain. The rubber molding on the back edge is hollow inside. I put a 1/4" rod into the hollow molding and the shelf is straight again. If you are trying to get rid of weight, this is not the way to do it. But then if you are trying to get rid of weight, you would remove the shelf anyway.

I have a Starion from California with what looks to have no rust. I notice that water tends to gather up on the inside of the front fenders, right under the door hinge. I notice that I had wet mud so I flushed it out with a hose and suck it up with a vac.   Then I stuck a light bulb inbetween the door jamb in front to see. I looks almost all clean but found a tiny bit of rust starting, hard to see but about the size of a dime.   I dont wanna remove the front fender. So could I just dry out

Lately I've been having this problem with my car. Whenever I go to turn my headlights off in my car the switch gets stuck. It also happens on the other side where the switches are. I don't know what's up with this. Do I need to buy a whole new switchboard area or do I take it apart and clean it?? Also, where is a good site to purchase the headlights for the car?? Thanks

ive seen it in drawings, every1 has it but has it been done, has any1 put a universal evo hood scoop on there quest and any1 have pics of it?