Where to start? My setup, I guess. I'm running cable internet, two computers, dlink router, rca modem. I got home from work today and my main computer would log on, but ran VERY slow. I ran a speed test that dl'd some 2900kps, and only uploaded 6kps. I called Comcast and worked with one of their techs who told me my modem was bad. So I installed my spare and called them back. They came back and said they needed to register/activate/whatever the new modem, so they did. Now my main computer won't

Well, after the install of the MSD 6al, 8.5mm wires, 284 solid cam and lifters, 3" SLP muffler and side exit pipes, it made 310hp/342tq on the dyno at 20 psi. It made 285hp/340tq before at 23 psi before. I would have raised the boost up some more but I think my valve stem seals are leaking so I kept it conservative. I did a compression check just to make sure it wasn't the rings and it shows 150/150/148/148 so I think I'm ok there.    

Has anybody run into this.I replaced the RS door on my 87 with an 89 door.I wanted to use all the hardware from the 87 in the 89 door but the latch assem wouldnt fit....and now I know why.I had to use the original latch from the 89 and now the auto seat belt dosent work.The switch for the seatbelt control is in the latch,but the latch was to big to fit in the 89 door. Is it easier to wire up a seperate switch for that seatbelt?I was thinking of using the door jam switch for the interior li

anyone?   RJ