Ok so I assembled my MS1 V3.0 board and everything tested just fine .. phew. I didn't finish the jumpers for RPM input and spark control. I am not sure what option to use. Should I be using the VR sensor option, or have it set up for Hall senor/coil neg terminal/points. I am using the Msns extra firmware and I have an MSD 6a ignition still using the stock dizzy. I want to be able to control spark with the setup (eventually) but my main question is the RPM input. I believe I should set the jumper

I need the fuel line fitting that attaches the fuel hose to the mixer inlet on the throttle body, 87 starion.   I am also looking for a pigtail connector to use a 1G MAS with my 88 harness.

Now it is still a work in progress but are some pics   mine is the red one http://i43.photobucket.com/albums/e394/XLR8N/P3290010.jpg http://i43.photobucket.com/albums/e394/XLR8N/P3290008.jpg http://i43.photobucket.com/albums/e394/XLR8N/P3290002.jpg

I went to the junk yard this weekend to find a 1G Steering wheel for my car. While I was there I found two others. One has the eagle head on the wheel and the other has Plymouth on it.   $20.00 plus shipping I am in VA 23146.