I'm tired of trying to track down a good set of tan seats to go in it so I'm changing out all the tan parts to black.   Overall condition is pretty nice. One door panel has a small rip that is pictured. Carpet has been scrubbed clean using Burtons method and it looks really nice now.   carpet $40http://img71.imageshack.us/img71/1310/0618070814na1.jpg rear side bolsters $30 pairhttp://img240.imageshack.us/img240/455/0618070826xh1.jpg Door panels $50 for the pairhttp://img239.imageshack.us/img239

Mallory-6853M-Hyfire-VI-AL-6AL-Ignition-w-Rev-Limiter   looking for $150 shipped.. everyplace i found online they go for around $175 new   this is a used peice.. it was used for a few months on a different car i had.. i didnt wire it up, a friend of mine did for me.. so i have no idea how to wire it up on another car.. or i would have done it on my quest already lol... Ill entertain offers... but right now i need a new turbo so id like to get $150 shipped for it ...

SDS EM-4E comes with tune to match my set up, parts that are included soild crank pully with magnets installed by Chad hall sencer and bracket made by chad Modded dist with cap and rotor for the sds IAT CTS 3 bar MAP includes the fuel pump relay option "for a 3 sec prime when key is turned on" idle air control valve "iac" a must need if you are keeping you A/C and all the other wires to make it complete this is a bolt in ems. All the hard work is done. give it power and ground and you u

I need a good bottom end or whole engine. As close to mid michigan as possible.